A reference point for each area of the house
A slab house with a pier and beam addition, a garage that steps down, a porch: give each area its own 0.0 so each gets its own spread.
Steps
Draw the outline of each area (a room or a rectangle). Tap it, then tap Own reference point on the bar (on a phone: •••, Own reference point (0.0)…).
Pick the name (Main house, Addition, Garage, Porch, Patio or Other…), then the foundation: Slab on grade, Pier & beam or Other.
Type the readings as usual. Each reading belongs to the area it sits in. To move one, tap it, •••, Move to zone….
Tap the reading you shot as that area's zero and tap Set as reference for this zone. Only that area's readings change.
A porch or patio you do not want in the house numbers: tap it, •••, Leave out of the house spread.
The heat map colors each area on its own, its legend lists each area with its foundation and spread, and the proposal's findings give each area its own range.
In the app, open Help & guides and tap Show me: FollowStack points at each button as you go.
Related guides
- Run a guided inspection
- Send the inspection report
- Do a TREC home inspection
- Do a Texas wood destroying insect report
- Turn a plan picture into a drawing
- Place piers around the house
- Scan the whole house with LiDAR
- Start a drawing from the address
- Show the drawing in 3D and share it
- Add stairs and porch steps
- Measure a roof and send the roof report
- Turn an area into materials with kits
- Record the products you apply
- Keep each home equipment and its service history
- Plan drainage and grading
- Track cracks over time
- The yearly follow-up visit
- Take and file job photos
- Make a 360 tour